Metrohm VoltIC pro I - Manual (Page 8)

Application Bulletin 356
Installation instruction for «VoltIC pro I»
Page 8 of 18
Fig.: schematic configuration of the VoltIC pro I system
a) PEEK, 70 cm, d=0.75 mm, 6.1831.070 / b) PTFE, 90 cm, d=0.25 mm, part of 6.1803.150 / c) PEEK, 90 cm, d=0.50 mm, part of 6.1822.410 /
d) FEP tube, 6.1805.530 / e) Fourfold micro tip, 6.1824.000 / f) FEP tube, 6.1805.530 / g) PTFE, 40 cm, d=0.50 mm, part of 6.1803.030 / h)
Heavy metal multistandard solution / i) buffer solution pH 4.6 / j) ultrapure water / k) rinsing solution for VA / l) anion eluent / m) cation eluent / n)
rinsing solution for rinsing station
3 Software
3.1 Installation of an Serial port (RS) printer
The data generated in the VA Computrace software is being
transferred to MagIC Net ™ via a generic text printer. The
following steps describes how a generic text printer is being
installed under Windows 7.
Check the newly created COM-ports in your system after
connecting the null modem cable and USB RS adapters
(refer 2.1): Start  Control Panel  Device Manager
Under Ports (COM&LPT) the newly created USB serial ports
are visible (e.g. COM14 and COM15):