Metrohm 882 Compact IC plus – Anion – MCS User Manual
882 compact ic plus
Table of contents
Document Outline
- Table of contents
- Table of figures
- 1 Introduction
- 2 Overview of the instrument
- 3 Installation
- 3.1 About this chapter
- 3.2 Initial installation
- 3.3 Installation diagram
- 3.4 Setting up the instrument
- 3.5 Capillary connections in the IC system
- 3.6 Installations on the rear of the instrument
- 3.7 Capillary and cable feed-throughs
- 3.8 Eluent
- 3.9 High pressure pump
- 3.10 Inline filter
- 3.11 Pulsation absorber
- 3.12 Injection valve
- 3.13 Peristaltic pump
- 3.14 Metrohm Suppressor Module (MSM)
- 3.15 Metrohm CO2 Suppressor (MCS)
- 3.16 Connecting the instrument
- 3.17 Guard column
- 3.18 Separation column
- 4 Start-up
- 5 Operation and maintenance
- 5.1 General notes
- 5.2 Capillary connections
- 5.3 Door
- 5.4 Eluent
- 5.5 High pressure pump
- 5.6 Inline filter
- 5.7 Injection valve
- 5.8 Inline sample preparation
- 5.9 Rinsing the sample path
- 5.10 Peristaltic pump
- 5.11 Metrohm Suppressor Module (MSM)
- 5.12 Metrohm CO2 Suppressor (MCS)
- 5.13 Separation column
- 5.14 Quality Management and validation with Metrohm
- 6 Troubleshooting
- 7 Technical specifications
- 7.1 Reference conditions
- 7.2 Instrument
- 7.3 Leak sensor
- 7.4 Ambient conditions
- 7.5 Housing
- 7.6 High pressure pump
- 7.7 Injection valve
- 7.8 Peristaltic pump
- 7.9 Metrohm Suppressor Module (MSM)
- 7.10 Metrohm CO2 Suppressor (MCS)
- 7.11 Mains connection
- 7.12 Interfaces
- 7.13 Safety specification
- 7.14 Electromagnetic compatibility (EMC)
- 7.15 Weight
- 8 Conformity and warranty
- 9 Accessories
- Index