Metrohm 882 Compact IC plus – Anion – MCS - Manual (Page 59)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
882 Compact IC plus – Anion – MCS
￭￭￭￭￭￭￭￭ 49
1 2
3
4 4 5 5
6 7
Figure 25 MCS – connection
1 MCS input
Connection to the MSM. 2 MCS output
Connection to the detector.
3 Aspirating capillary
For aspirating air low in CO
2
(as a result of
CO
2
adsorption cartridge (26- 4 )).
4 PEEK pressure screw, long
(6.2744.090)
5 Capillary connection 6 Pressure screw, short (6.2744.070)
Mounted on the air aspirating capillary.
7 Luer coupling (6.2744.120)
Mounted on the air aspirating capillary with
pressure screw 6.2744.070.
Connecting the MCS
1 Connecting the MSM
Connect the eluent outlet capillary (labeled with out) to the MCS
inlet (25-1) using a long PEEK pressure screw (6.2744.090) (25-4).
2 Connection to the detector
Connect the detector inlet capillary to the MCS output (25-2) using a
long PEEK pressure screw (6.2744.090) (25-4).
Caution
If the MCS is not used, the input and output must be sealed with
6.2744.220 stoppers.