Metrohm NIRS XDS MultiVial Analyzer - Manual (Page 100)

98 ▪▪▪▪▪▪▪
Remove the power cord for access to the fuse.
Use a tool (such as an Allen wrench) to pull the
housing open.
There is a small slot, underneath the fuse door
and in the center, where the tool can be inserted
to pry the door gently open.
Remove old fuses from holder and discard. Install
the new fuses as shown.
Fuse Ratings:
• 5A 250 VAC, 5 x 20mm
• Slo-Blo
• (2) Required
The new fuses clip into the plastic holder, and
should be positioned at the center of the holder.
Close the fuse door fully.