Metrohm NIRS Analyzer PRO - Manual (Page 63)

▪▪▪▪▪▪▪ 61
1. Please verify that the
Sampling System appears as
shown below, in the area
marked by the box.
There is no need to set “Cell”
or Detector” as these
selections default to the
proper settings.
2. Verify that the instrument is
correctly shown, and that the
Sample Module Type is
“Direct Light”.
Click “OK”.
13.3.1 Performance Test
Follow these steps to run Performance Test:
1. Click on “Analyzer PRO Setup/Diagnostic”, then “Run
Performance Test”.