Metrohm NIRS Analyzer PRO - Manual (Page 23)

▪▪▪▪▪▪▪ 21
This photo shows an installation on a chute,
where the product falls by gravity onto the
sample window, thus providing a suitable
measurement.
The Weld Flange is bolted to a plate which
mounts in the duct. The plate may be removed
if needed, and replaced with a blank plate. This
allows cleaning and minor maintenance,
without stopping the line for more than a brief
interval.
Note that the Analyzer PRO is supported by
straps on each side, which support the weight.
The Weld Flange does not support the weight
of the instrument.
This shows the weld flange mounted on the
Analyzer PRO. The Tri-clamp is used to secure
the instrument in place on the weld flange.
NOTE: The Weld Flange provides positioning of
the sample window only. It does not support
the weight of the Analyzer PRO instrument.