4 performing titrations, 1 preparing single determinations, 2 preparing sample series – Metrohm TiNet 2.5 User Manual

Page 48: 3 buttons for titrations

46 • Titrations

TiNet 2.5 Compliant

5.4 Performing

titrations

5.4.1

Preparing single determinations

Before starting single determinations, proceed as follows:

• Connect, switch on and initialize devices (see section 2.1).
• Start TiNet 2.5 Compliant.
• Disable the

Autostart

option on the

Sample data

tab (see section

5.2.1).

• Enter method and sample data on the

Sample data

tab (see section

5.2.1), or

• Enable the

Silo

option on the

Sample data

tab and enter method and

sample data in the silo memory (see section 5.3.1)

5.4.2

Preparing sample series

Before starting single determinations, proceed as follows:

• Connect and initialize devices (see section 2.1).
• Enable the

Autostart

option on the

Sample data

and enter the number

of samples (see section 5.2.1).

• Enter method and sample data on the

Sample data

tab (see section

5.2.1), or

• Enable the

Silo

option on the

Sample data

tab and enter method and

sample data in the silo memory (see section 5.3.1)

5.4.3

Buttons for titrations

The individual buttons in the main window have the following meaning:

Starts the determination. The button is shown gray
when it is not active.

Stops the determination. The button is shown gray
when it is not active. Can also be used as an emer-
gency stop. If a Titrino stops, TiNet must be
stopped manually.

Continues with the determination after hold by
"Wait/Message/Request" block. The button is shown
gray when it is not active.

Start conditioning. The button is shown gray when it
is not active.