Brother P-TOUCH PT-2030 - Manual (Page 52)

LABEL PRINTING
46
Adjusting the Label Length
You can adjust the length of the printed label in levels of -5 to +5.
Press the Setup key to display the setup menu, select "Adjust Length" using the
or key, and then press the OK or Enter key.
Select "Adjust Length" by using the or key, and
then set the value by using the or key.
Press the OK or Enter key to apply the setting.
If necessary, trim the printed label to the desired shape and length using scissors, etc.
Peel the backing from the label.
Position the label and then press firmly from top to bottom with your finger to
attach the label.
Chain
• Use this setting when printing several
labels with minimum margins.
• Feed the tape before using the cutter.
Otherwise a part of the text may be cut off.
Do not try to pull the tape since this may
damage the tape cassette.
• After pressing Print, “OK to Feed?”
appears.
Press the Escape key to enter more texts
or press the OK or Enter key to feed.
• The final label is printed with an 0.37" (9.4
mm) margin to the right of the characters.
Use scissors to cut off any part of this
margin that is not required.
Setting Description Example
ABC ABC
*Feed the tape before
using the cutter.
0.37"
(9.4 mm)
Adjusting the Label Length
1
2
3
• Press the Escape key to return to the previous step.
• Press the Space key to set the value to default setting.
• Approximately 1% of the total label length will be adjusted by 1 level.
Attaching Labels
1
2
3