Brother P-TOUCH PT-2030 - Manual (Page 43)

1
2
3
4
5
6
7
8
9
37
z
EDIT
ING A LA
BEL
Creating a Bar Code Label
Using the Bar Code function you can create labels with one dimensional bar codes for
use with cash registers, stock control systems or other bar code reader systems, or
even asset control tags used in an asset management system.
Setting Bar Code Parameters
Press the Setup key to display the Setup menu, select “Bar Code Setup” using
the or key, and then press the OK or Enter key.
The Bar Code Setup screen is displayed.
Select an attribute using the or key, and then set a value for that attribute
using the or key.
Press the OK or Enter key to apply the settings.
Creating a Bar Code Label
• The P-touch labeler is not designed exclusively for creating bar code labels. Always
check that bar code labels can be read by the bar code reader.
• For best results, print bar code labels in black ink on white tape. Some bar code readers
may not be able to read bar code labels created using colored tape or ink.
• Use the “Large” setting for “Width” whenever possible. Some bar code readers may not
be able to read bar code labels created using the “Small” setting.
• Continuously printing a large number of labels with bar codes can overheat the print
head, which may affect printing quality.
1
Pressing Bar Code key while holding down the Shift key will also allow you to go
to "Bar Code Setup".
2
Characters may not appear below the bar code even when "On" is selected for "Under #",
depending on the tape width being used, the number of lines entered, or the current
character style settings.
3
• New settings are NOT applied if you do not press the OK or Enter key.
• The "C-Digit" (Check Digit) attribute is only available for the CODE39, I-2/5 and CODABAR
protocols
• Press the Escape key to return to the previous step.
• Press the Space key to set the selected attribute to the default value.
• Refer to the Bar Code Settings table for a list of all available settings.