Brother P-TOUCH PT-2030 - Manual (Page 51)

1
2
3
4
5
6
7
8
9
45
z
LA
BEL PRIN
TING
Setting Margin
The tape cutting options allow you to specify how the tape is fed and cut when printing
labels. In particular, the “Chain” options greatly reduce the amount of wasted tape by
using smaller margins and eliminating blank sections cut between labels.
Press the Label key to display the Label menu.
Select "Margin" using the or key, and then set the value by using the or
key.
Press the OK or Enter key to apply the settings.
z
Tape Cutting Options
z
Setting Margin
1
2
3
New settings are NOT applied if you do not press the OK or Enter key.
• Press the Escape key to return to the previous step.
• Refer to the Tape Cutting table for a list of all available settings.
Setting Description Example
Full
Each label is printed, leaving a margin of
0.98” (25 mm) on each end.
Half
• A margin of 0.98” (25 mm) is printed first,
and then each label is printed, leaving a
margin of 0.47” (12 mm) before and after
the text.
• Dots (:) are printed in front of the text. Cut
along the printed dots (:) with scissors.
Narrow
• A margin of 0.98” (25 mm) is printed first,
and then each label is printed, leaving a
margin of 0.16” (4 mm) before and after the
text.
• Dots (:) are printed in front of the text. Cut
along the printed dots (:) with scissors.
ABC
0.98" (25 mm)
0.98" (25 mm)
ABC
:
0.47"
(12 mm)
0.47"
(12 mm)
0.98" (25 mm)
ABC
:
0.16"
(4 mm)
0.16"
(4 mm)
0.98" (25 mm)