Metrohm 877 Titrino plus - Manual (Page 19)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
877 Titrino plus
￭￭￭￭￭￭￭￭ 9
NOTE
The electrode cable is protected against accidental disconnection of the
cable by means of a pull-out protection feature. If you wish to remove
the plug, then you must first retract the outer plug sleeve.
Connecting a reference electrode
Figure 4 Connecting a reference electrode
Connecting a temperature sensor or an electrode with inte-
grated temperature sensor
Temperature sensors of the Pt1000 or NTC type can be connected to the
Temp. connector.
Figure 5 Connecting a temperature sensor
NOTE
The red plug must always be plugged into the red socket at the temper-
ature sensor for the purpose of shielding against disruptions.
If you use an electrode with an integrated NTC probe, then you must
plug the red plug into the red socket.