Metrohm 877 Titrino plus - Manual (Page 100)

7.2 Endpoint titrations (SET)
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
90 ￭￭￭￭￭￭￭￭
877 Titrino plus
Input range 0.00000 - 9999.99 mL
Default value 100.000 mL
Selection off
Stop time
The titration is stopped when the specified time has elapsed following the
termination of the start conditions.
Input range 0 - 999999 s
Selection off
Default value off
Filling rate
Rate at which the dosing cylinder is filled after the titration. The maximum
filling rate depends on the cylinder volume (see Chapter 10.1.1, page
101).
Input range 0.01 - 166.00 mL/min
Selection max.
Default value max.
7.2.7 Calculation
7.2.7.1 General
Menu ▶ Parameters ▶ Calculation
A maximum of five calculations can be defined in one method. A series of
variables (raw data from the determination, previously calculated results) is
available for the calculations. Definition can be made for each calculation
as to whether the result is to be saved as a titer or as a common variable.
The result name is specified in the list for each calculation.
Edit
Edit the data of the selected calculation, see following chapter.
Delete
Delete the selected calculation.