Metrohm 889 IC Sample Center - Manual (Page 21)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
889 IC Sample Center
￭￭￭￭￭￭￭￭ 13
3 Installation
3.1 Setting up the instrument
3.1.1 Packaging
The instrument is supplied in highly protective special packaging together
with the separately packed accessories. Keep this packaging, as only this
ensures safe transportation of the instrument.
3.1.2 Checks
Immediately after receipt, check whether the shipment has arrived com-
plete and without damage by comparing it with the delivery note.
3.1.3 Location
The instrument has been developed for operation indoors and may not be
used in explosive environments.
Place the instrument in a location of the laboratory suitable for operation
and free of vibrations, if possible protected from corrosive atmospheres
and contamination by chemicals.
The instrument should be protected against excessive temperature fluctu-
ations and direct sunlight.
3.1.4 Removing the device from the packaging
Grip the device at the positions marked with arrows and lift it out of the
packaging.
Figure 6 Unpacking the 889 IC Sample Center
Grip the device underneath with both hands when you are transporting it.
Always hold the device in an upright position.
Before you switch on the 889 IC Sample Center, allow the device to stand
for at least one hour in order to adapt to the room temperature.