Embroidering, using embroidery hoop, Set your sewing machine as per following table, Remove presser foot – Brother 681B-UG User Manual

Page 29: Draw design on the material, Use embroidery hoop as you would for, Monogramming, Pull lower thread up through material

EMBROIDERING, USING EMBROIDERY HOOP

SET YOUR SEWING MACHINE AS PER FOLLOWING TABLE.

1. Remove presser foot.
2. Draw design on the material.
3. Use embroidery hoop as you would for

monogramming.

4. Position the hoop under the needle and

lower presser bar.

5. Pull lower thread up through material.

6. Stitch outline of design by removing

embroidery hoop accordingly.

7. To fill in design stitch from outline of

design to inside and from inside to edge
of outline alternately until design is
completely filled in. Keep stitching close
together.

NOTE: A long stitch is made by removing

embroidery hoop rapidly and a short
stitch is made by moving it slowly.

-27-