Sew-light, To change the bulb, Swing open face plate – Brother 681B-UG User Manual

Page 13: Remove bulb by turning counter-clockwise, After replacement, close the face plate, Note, Presser foot, To remove the presser foot, Raise needle to its highest position, Raise presser foot

Sew-Light

To change the bulb:
1. Swing open face plate.
2. Remove bulb by turning counter-

clockwise.

3. After replacement, close the face plate.

NOTE:
1. Make sure new bulb is the same

specification as old one.

2. Make sure to switch off the light and

pull out supply plug when you replace
the bulb in order to avoid electric
hazards.

Presser Foot

To remove the presser foot;
1. Raise needle to its highest position.
2. Raise presser foot.
3. Loosen presser foot thumb screw and remove presser

foot.

4. To attach the presser foot, place grooved side of the

foot against the flat of the presser bar.

5. Tighten thumb screw.

-11-