DJI Naza-M Lite - Manual (Page 4)

©2014 DJI. All Rights Reserved. 4
In The Box
Main Controller (MC) × 1
The Main Controller (MC) is the brain of the system, it communicates with all
ESCs and RC transmitter to carry out the autopilot functionality. It has a built-
in Inertial Measurement Unit (IMU) consists of one 3-axis accelerometer, one
3-axis gyroscope and a barometer for sensing the attitude and altitude.
Versatile Unit (VU) × 1
Specially desig ned for NAZA-M LITE. It solves the high power consumption
problem of multi-rotor system, supply and monitor power for NAZA-M LITE
and other electronic devices. It also has an LED to indicate different
operating states of NAZA-M LITE and a USB interface for configuring the
NAZA-M LITE unit and firmware upgrade.
Optional GPS & Compass Module × 1
The GPS/Compass module is for sensing the position and direction.
Optional GPS Bracket × 1
Because the GPS & Compass are sensitive to magnetic interference, you should use this bracket to mount the
GPS module.
USB Cable × 1
This cable is used to configure MC and upgrade firmware.
3-PIN Servo Cable × 8
Cables used to connect the MC and the receiver.
3M Gummed Paper × 4
Used for fixing NAZA-M LITE components on multi-rotor’s frame.