DJI Naza-M Lite - Manual (Page 12)

©2014 DJI. All Rights Reserved. 12
Firmware Upgrade
Please follow Word for Word in the procedure for firmware upgrade; otherwise the autopilot might not work properly.
For SAFETY REASONS, DO NOT use power battery during firmware upgrade.
1. Make sure your computer is connected to the Internet before you connect the USB cable to the MC.
2. Please close all the other applications during the firmware upgrade, including anti-virus software and
firewall.
3. Make sure the power supply is securely connected. DO NOT un-plug the power supply until firmware
upgrade has finished.
4. Connect MC to PC with micro-USB cable, DO NOT break connection until firmware upgrade is finished.
5. Run Software and wait for connection.
6. Select Upgrade page.
7. Server will check your current firmware version, and get the latest firmware prepared for the unit.
8. If there is a firmware version more up-to-date than your current version, you will be able to click the
Upgrade button.
9. Wait until Assistant software reads finished.
10. Click OK and cycle the power of the unit after at least 5 seconds.
Your unit is up-to-date now.
Notices:
 After firmware upgrade, please re-configure the MC by Using the Assistant software.
 If the network or server is busy, please try again later with above procedures.
 If firmware upgrade failed, MC will enter waiting for firmware upgrade status automatically, please try
again following the above procedures.
Product Info
You can check the Assistant Software version via Info.
S/N is a 32 digits authorization code for unit function activations. We had already filled in the authorization code for
your unit after manufacture. In the Future you might be asked to fill in the new S/N in the future if you brought new
function upgrades. Fill-in the S/N and then click Write button. If you filled in an invalid S/N over 30 times, your MC
will be locked and you have to contact our customer support.