DJI Naza-M Lite - Manual (Page 14)

©2014 DJI. All Rights Reserved. 14
2 Mounting
Install all payloads that will be used during the flight, including batteries, camera mount and camera. Balance the multi-
rotor as you would normally, with the center of gravity (C.G.) directly on the center plate. Fill in the distance between
body center of GPS and the C.G. of multi-rotor in X, Y & Z axles as showed in the figure.
Make sure the MC ESC ports is pointing to the aircraft nose direction, otherwise serious damage will occur to your
aircraft.
When MC mounted, try your best to mount the MC at the center of the frame, and do not mount the MC upside-
down. Make sure MC is parallel to the aircraft horizon.
Notices
:
1 Users with GPS module please mount GPS location.
2 Please follow the requirements to mount your NAZA-M LITE MC, so as to prevent the aircraft from
abnormal, such as drifting in horizontal direction, or even rollover.
3 You must re-configure if the ALL-UP-WEIGHT had been changed on your multi-rotor,
4 If GPS mounting locations are not accurate enough or the signs are wrong, error on X, Y，Z axles will leads
the oscillation of your multi-rotor.
5 Make sure to follow the diagram in our assistant software: red is positive, green is negative; unit of measure
is CM, NOT INCH.