DJI S1000 Plus - Manual (Page 7)

© 2014 DJI. All Rights Reserved.
7
Mounting Frame Arms
Instructions
1. Prepare the arms.
(1) Check all propellers for cracks, then install and screw each propeller cover on tightly.
(2) Ensure all motors are mounted firmly and rotate freely.
(3) Mount all arms with red propeller covers to M1 and M2 to indicate the nose of the S1000+.
(4) Identify the CW and CCW marks on the arms. Mount the arms with the CCW mark to the M1, M3, M5
and M7 positions of the center frame. The arms with the CW mark should be mounted to the M2, M4,
M6 and M8 positions of the center frame.
2. Insert each frame arm vertically into the mounting
area on the center frame.
3. Line up the screw holes of the frame arm and
center frame.
4. Insert the M4x35 screw from the right of the frame
arm (the thread is located on the left of the screw
mount). Tighten each screw correctly. Over
tightening may lead to connector abrasion.
Propeller Cover
Screw
Motor
ESC
CW or CCW Mark
LED*
Screw Mount Power Cable
ESC Signal Cable
*LED is on after motor started.
Mounting Frame Arms