DJI S1000 Plus - Manual (Page 14)

Spreading Wings S1000+ User Manual
14 © 2014 DJI. All Rights Reserved.
Mounting Electronics and Wiring
If using a DJI WK-M flight control system, you must use the wires that came with the WK-M. M1 through
M6 correspond to each motor number. M7 corresponds to F1 and M8 corresponds to F2 on the WK-M.
Connecting the flight controller to the center frame
1. Connect the flight control system according to your flight control system user manual.
2. Plug in the connector cables to the ESC signal outlet on the center frame. Then plug in the connector
cables to the flight controller as shown below.
(1) Yellow 4-pin cables are for M1~ M4 connections. The yellow cable should be connected to M1.
(2) Brown 4-pin cables are for M5~ M8 connections. The brown cable should be connected to M5.
(3) Black 4-pin cables are for four continuous ground pins connections. M1~M4 are connected as the
following diagram shows.
the ESC Signal Outlet
the ESC Signal Outlet WKM Flight Controller
A2 Flight Controller
M1
2
3
4
5
6 M
M
M
M
M
M
M
7
8
M1
M2
M3
M4
M5
M6
M7
M8
3
1
8
7
4
2
5
6
4
6
7
8
3
5
2
1
M1
2
3
4
5
6 M
M
M
M
M
M
M
7
8
1
2
3
M1
M2
M3
M4
M5
M6
M7
M8
1
2
3
M1
M2
M3
M4
M5
M6
M7
M8
brown
yellow
yellow
brown