DJI S1000 Plus - Manual (Page 24)

24 © 2014 DJI. All Rights Reserved.
Remounting the Propellers
Instructions
1. Use two M3x12.3 screws and four washers to remount propellers.
2. Apply thread locker to the thread of the propellers mount first.
3. Affix screws with 3Kg ∙ cm (0.3N ∙ m) torque.
Refer to original screw tensions if you are unfamiliar with torque measurements. Applying thread
locker to the propeller mount first avoids getting thread locker into the holes of the plastic propeller.
Loose screws cannot be securely locked with thread locker.
G
V
G
P
G
V
G
P
Red
Black
Blue
Thick wire
Solder pad
Blue
Black
Red
Fine wire
Fine wire
Thick wire
CCW arms CW arms
Propeller Precautions
Torque markers on the screws and propeller covers will give you a visual cue to check whether the propellers
are loose. Check the torque markers before every flight.
FAQ
Soldering the ESC
Be sure to solder the thick wires and fine wires correctly when soldering an ESC to the frame arm.
Clockwise (CW) and counter clockwise (CCW) motors have a different arrangement of the colored wires.
FAQ