DJI S1000 Plus - Manual (Page 16)

16 © 2014 DJI. All Rights Reserved.
Connecting XT60 Ports on the Center Frame
The bottom board is a power distribution board with three XT60 connectors for battery power.
Instructions
1. Connect the PMU power cable to the XT60 connector on top of the bottom board.
2. Connect the landing gear control board cable to the XT60 connector on the bottom of the bottom board.
3. Other connectors can supply power for other DJI devices, as required.
Installing Battery
Soldering battery connectors
AS150 spark-proof connectors are used. They must be soldered to your battery power cables.
1. Remove the original battery connectors. Avoid cutting the power and ground cables at the same time, as
this can cause a short circuit. We recommend wrapping unsoldered cables with insulating tape to prevent
accidental connections.
2. Pass the black ground wire through the black housing. After passing the wire through, solder the female
bullet connector to the ground wire. Wait for the soldered connection to cool, then pull the housing back
over the bullet connector.
3. Screw and pass the red power wire through the red housing. After passing the wire through, solder the
male bullet connector to the power wire. Wait for the soldered connection to cool, and then screw and pull
the housing back over the bullet connector.
Connectors soldering diagram
Connecting XT60 Ports on the Center Frame
/ Installing Battery