DJI S1000 Plus - Manual (Page 25)

Spreading Wings S1000+ User Manual
© 2014 DJI. All Rights Reserved.
25
Using the Propeller Holder
Instructions
1. Insert the propeller blades into the propeller holder. 2. Attach the propeller holder to the frame arm.
Assembling Motor Vibration Absorbers
A soft damper is part of the vibration absorber. Assemble soft dampers as shown below. Assembly is the
same for CCW and CW propellers.
Ensure all soft dampers and vibration absorbers are in good condition before every flight. If not,
replace immediately. Otherwise, the flight performance of your aircraft will be adversely affected.
Before installing the soft dampers, put the copper gaskets onto the four mounting holes on the
carbon plate. Then put the soft dampers into the mounting holes.
After tightening the screws, the vibration absorbers may be twisted. If this is the case, hold the
motor with your thumbs under the base plate and fingers on the top carbon plate, and squeeze the
plates together to make the vibration absorbers flat and parallel with the plates.
FAQ