Rl in, Connecting the flight controller and landing gear – DJI S1000 Plus User Manual
Page 15
Spreading Wings S1000+
User Manual
©
2014 DJI. All Rights Reserved.
15
If right and left servo cables are reversed, the landing gear will not function properly.
Connect all wires carefully and neatly to avoid cable damage caused by frame edges.
Connecting the flight controller and landing gear
1. Connect the left servo (between M3 and M4) cable to the “L” port of the landing gear control board.
2. Connect the right servo (between M7 and M8) cable to the “R” port of the landing gear control board.
3. For the A2 flight control system, connect the F1 port of the flight controller to the “IN” port of the landing
gear control board. Other flight control systems connect a 2-position channel receiver to the “IN” port.
Mounting Electronics and Wiring
Right Servo Connector
Left Servo Connector
R
L IN
R
L
IN
F1
R
L IN
R
L
IN
F1