Utp indoor cable – CommScope Drop Cable User Manual
Page 9
UTP Indoor Cable
Unshielded twisted pair (UTP) cables consist of two insulated conductors twisted together in a very precise fashion;
four of these pairs are then jacketed together into a cable. The angle and number of the twists acts like a shield
and helps the digital signal stay robust over longer distances. UTP is used inside buildings to distribute voice and
data signals over relatively short distances.
Through advances in construction and materials, UTP cables have a much higher bandwidth (information carrying
capacity) than their telephone wire cousins. Most UTP cables are defined by a ‘category’ or a performance des-
ignation. The categories are roughly determined by the bandwidth, or information-carrying capacity, of the cable.
Category 5 (a data cable rated at 100 mHz of bandwidth) is the most commonly used type in residences. For
higher data speeds and increased bandwidth, CommScope also offers Ultra II™ enhanced Category 5e (200
mHz) and UltraMedia™ Category 6 (400 mHz) cables.
Maintaining the twist is essential, especially during connectorization - the conductors must remain
twisted right up to where they meet the jack. The loss of just one twist can degrade the performance of the cable so
as to render it useless as a high-speed data cable.
UTP cables consist of three basic components:
The conductor is 23 or 24 AWG solid bare copper;
The insulation is usually a solid PE (foamed for UltraMedia)
with FEP used in plenum cables; and
The jacket is a riser-rated PVC or plenum-rated FEP or PVDF.
Because these cables are used indoors, pay special attention to
the NEC rating of the application.
24 or 23 AWG
solid copper conductors
polyethylene
insulation
4 twisted pair
components
PVC jacket
Cable
Descriptions 2.3
UTP Cable Descriptions