Locating and cutting outlet holes – CommScope Drop Cable User Manual
Page 38
Locating and Cutting Outlet Holes
Once outlet locations are determined, cut the holes as required. Carefully check the area for any possible ob-
structions, such as wall studs, plumbing or electrical wires. Be aware that obstructions like windows or interior
openings like kitchen passthroughs may cause problems with dropping cables from above. Pocket doors are an-
other concern; make sure the planned outlet is outside of their open range. Keep an eye open for creative routes
to hide cable, such as running within closets.
Once you’ve settled on the precise locations, prepare to cut the holes
(1) Mark the Location
A communications outlet consists of the mounting bracket, the feet (which hold the bracket in the wall) and the
faceplate. Using the mounting bracket as the template, trace a cutting pattern on the drywall, making sure there
are no studs behind it. Match the orientation (vertical or horizontal) with the other outlets in the room and make
sure your planned cut is level.
(2) Cut the Opening
Using a drywall knife, utility knife or saw, cut the opening. Do
not install the bracket yet; the metal edges may damage the
cable during pulling and installation.
(3) Run the Cable
Once the cable has been run, you may install the bracket and
terminate the cable (see page 9.12/Trim out and finish).
Other Wall Surfaces
Older homes may have plaster and lathe walls that will require
a small rotary saw, or a cutout tool to cleanly penetrate and cut. Masonry walls will require a surface-mounted
box screwed into the brick and a cable raceway to hide the cable.
9.3 Residential Interior Cabling
Cutting Outlet Holes