CommScope ConQuest Conduit Construction - Manual (Page 55)

ConQuest
®
Toneable Conduit
TM
7.4
Coupling
Figure 4
Join the conduits with an approved coupler according to the manufacturer’s directions.
Strip back 5/8” of the HDPE jacket from around the tone wire (Figures 5 and 6).
Figure 5 Figure 6
CommScope recommends the use of large direct-bury waterproof connectors for joining the tone wires and providing
environmental protection (Figure 7). These can be purchased off the shelf at most home improvement stores. They
should be UL Listed as a 486D wire connector system for use with underground conductors for use in damp or wet
conditions.
Figure 7