Brady 1024 - Manual (Page 27)

Printing Labels 21
A STX L Command switches the Printer from the System Level to the
Label-Formatting Mode. All command characters after STX L are
interpreted as Label Formatting Commands until the Label Formatting
mode is terminated with the command character E. All Label Formatting
Commands are terminated with hex value 0D.
CC Description Format
: Set cut by amount (4 digits)
The cutter function will perform a cutting
action after the number of labels specified. :nnnn
nnnn = 4 digits of labels printed
before cut. Default = 0001
A Set format attribute An n=1-XOR, 2-Transparent, 3-
Opaque, 5-Inverse
C Set column offset amount Cnnnn nnnn= in/100 or mm/10
c Set cut by amount (2 digits) cnn nn = 2 cut amount
D Set height and width dot size h = Horiz. dot size; can be 1 or 2
v = Vert. dot size; can be 1,2, or 3
(0.005" steps) Default is “D22”
E Terminate field generation and print label
G Place data in global register
H Enter heat setting
(The amount of heat applied per dot row, can
be used to help control print quality) Hnn nn = 2 digits. 1 - 30
10 is nominal and default
m Set metric mode The Printer must be reset in
order to return to standard
measure
M Set mirror image mode
('Mirror Images' current formatted label) 'M' must be re-sent to cancel.
* Will not mirror polygons.
P Print speed Px x x = A -C (1.0 to 2.0 ips)
p Set label backup speed px x x = A -C (1.0 to 2.0 ips)
Q Enter quantity of labels to print Qnnnn nnnn = quantity
R Set row offset amount Rnnnn nnnn = in/100 or mm/10
r Recall stored label format rnn...n nn...n Label name of up
to 16 char. terminated by CR.
S Slew (feed) speed Sx x x = A -C (1.0 to 2.0 ips)
s Store label format in module sann...n a - destination module
A Memory Module A
nn...n - label name (16 char.
max)
T Set field data line terminator Tnn nn = 2 digit ASCII Hex
00 - FF
U Make previous field a string replace field
Table 2-4 Label-Formatting Commands