Brady 1024 User Manual

Page 13

Getting Started

1.6

Loading Media

Due to its design, loading the Printer with media is a simple task. The
following steps outline the procedure.

Note: If your Printer is equipped with the External Media Supply Option

then you would load the media from the rear of the Printer.

1. Open the Printer's Top Cover.

2. Release the Printhead Carrier Assembly by pushing the Printhead

Latch. Raise the Assembly to its up position.

3. Place a roll of the chosen media on the Media Hub and place it in the

Printer. Ensure that the Media Hub is flush against the media.

4. Pull the media forward and out of the Printer. Ensure that the media's

labels are facing up.

5. Slide the Media Guide over until it is against the side of the media.

6. Close the Printhead Carrier Assembly, press down until it latches.

Figure 1-6 Media Loading

7. Close the Top Cover. Press the Feed Button several times to ensure

proper tracking.