Bully Dog 40440 GT for Jeep Manual - Manual (Page 61)

Typical types of sensors that can be used by the different docks or ports
P1-P2 (pyro 1 and 2)
• Bully Dog Type K
Thermocouple
an 1-an 3 (Analog 1-32)
• Manifold Pressure
• Oil Pressure
• Barometer
• Other Sensors with
Three Wire Five Volt
F in (Frequency IN)
• Engine RPM
• Vehicle Speed
• Output Shaft Speed
• Other Sensors that Send
a Pulse Signal
+5V out (temperature)
• Transmission Temp
• Oil Temp
• Intake Air Temp
• Ambient Air Temp
• Other Sensors with Two
wire Five Volt
P1: Pyro location #1
Y+: Positive yellow wire on Bully Dog Pyro
R-: Negative red wire on Bully dog Pyro
P2: Pyro location #2
Y+: Positive yellow wire on Bully Dog Pyro
R-: Negative red wire on Bully Dog Pyro
an 1: analog input location 1
+ AN 1: signal wire in from sensor
- AN 1: optional ground
an 2: analog input location 2
+ AN 2: signal wire in from sensor
- AN 2: optional ground
an 3: analog input location 3
+ AN 3: signal wire in from sensor
- AN 3: optional ground
F/in: Frequency Signal in
+5V/ oUT: 5 volt supply/ Signal out
o
2
Sensor Part # 40385 only
Bully Dog part number 40385 includes
a cable which will connect up to two
Bosch oxygen sensors to the Sensor
Docking Station.
Sensor Docking Station
Part# 40383 | 40384 | 40385
Dock Location Identification Diagram
P1 P2 AN1A N2 AN3F
- + + + Y+
PWR OXYGEN
R- Y+ R- - -
+5v
O
U
T
I
N
Sensor Diagram
60