Bird Technologies 6730B Series - Manual (Page 30)

Model 6735-300A
1. Replace the load assembly and the clamping
band.
2. Tighten the clamping screw.
3. Carefully lower the load back onto its feet.
Model 6736A and 6736-030A
Reverse disassembly procedure.
RF Load
Resistor
Reverse disassembly procedure.
Storage
No special preparations for storage are necessary other
than to cover the equipment to keep out dust and dirt.
Store these units in a dry and dust-free environment
where the ambient temperature will remain within the
-40°C to +45°C (-40F to +113F) working range of the
wattmeter
Shipment
Load
Portion
Wrap the RF connector with padding and tape the pad-
ding securely in place. Pack and brace the load in a suit-
able shipping container; a corrugated paper box should
suffice. It is not necessary to remove the dielectric coolant
before shipping. However, for Models 6735-300A, 6736A
and 6736-030A replace the vent plug with the shipping
plug; see page 10 for instructions.
Meter
Portion
Disconnect the dc cable from the voltmeter block and
then wrap the meter with padding and tape securely in
place. The meter can then be shipped in the same con-
tainer as the load portion.
Low
Frequency
Line
Section
If the low frequency line section is part of the equipment
as an extra accessory, wrap and tape it securely in pad-
ding before putting it in the container with the load and
meter.
Bird Model 6730B Series Termaline Wattmeter
22