Bird Technologies 4421 - Manual (Page 27)

IEEE-488 GPIB Interface
15
Device CLear (DCL)
Function Resets the status of all devices to an initialized state.
Remarks Does not change the current interface mode.
The 4421 returns to the factory default condition listed in Figure 5-6.
Table 5-6 IEEE-488 Default Conditions
Selective Device Clear (SDC)
Function Resets the status of a selected device to an initialized state.
Remarks Only the device addressed will be cleared.
The 4421 returns to the factory default condition.
Group Execute Trigger (GET)
Function Initiates a measurement for all devices set to trigger on GET.
Remarks The 4421 must be already set to trigger on GET.
Used to synchronize measurements of multiple instruments.
Default Condition Related Command
Forward Carrier Wave FC
Auto Range ON RYY
Two Terminators (CR LF) YT
Prefixes YES PY
Trigger One Shot on Talk Address T1
All SRQ’s OFF M00
Send EOI with last byte of message KY