Barco Coronis Fusion 10MP - Manual (Page 37)

Coronis Fusion 10MP 37
adjust certain video settings yourself. The start to this is selecting one of
the following image source selection modes available for your display:
T
O SELECT AN IMAGE SOURCE SELECTION MODE
:
1 Bring up the OSD main menu.
2 Navigate to the Configuration > Image Sources menu.
3 Enter the Image Source Selection submenu.
4 Select one of the available image source selection modes and
confirm.
Automatic In this mode, your display automatically
detects the connected video input signals,
attaches them to the correct display side
and applies the correct video settings to it
(resolution, video encoding mode, refresh
rate,...).
No video settings are available when this
mode is selected.
One Image Source This mode is intended for displaying and
manually configuring only one connected
video input signal.
When selecting this mode, the video
settings become available for the selected
video input signal.
Two Image Sources This mode is intended for displaying and
manually configuring two connected video
input signals (one on each display side).
When selecting this mode, the video
settings become available for the selected
video input signal on each side of the
display.