Bendix Commercial Vehicle Systems ACom Diagnostics V.5.9 - Manual (Page 10)

10
Antilock
The antilock section displays the current number of
sensors and modulators of the system.
Figure 18
Additional Axle for Trailer
The additional axle for trailer will display if the axle is a
lift or not lift axle only for confi gurations of 4S/2M and
4S/3M.
Figure 19
In Cab Trailer Lamp (for EC-30 ™ ECU ONLY)
There is a confi guration item for the In Cab trailer
lamp (PLC). The possible confi gurations are enabled
(meaning PLC is supported) or disabled (meaning PLC
is not supported).
Figure 20
Retarder
The retarder section displays the current control of the
retarder.
Figure 21
ATC
The ATC section displays the current confi guration of
the Automatic Traction Control system.
Figure 22
Odometer
The odometer section displays the current odometer
reading. The trip odometer reading is the odometer
mileage since the odometer was cleared. The service
odometer is the mileage left before service is needed.
Figure 23
Tire Size
The tire size section displays the current rolling radius
value programmed into the ABS ECU. These values
are for both tires on one axle. These are dependent on
the circumference of the tire, and how many complete
revolutions the tire makes over one mile. These values
should be obtained from the tire manufacturer and
typically are different for each tire model. The tool
assumes a tone ring with 100 teeth.
Figure 24
Note: The actual value of tire size may be slightly
different than the value inputted due to scaling of
calculation.
Figure 25
ESP
The ESP section displays a list of ESP parameters
stating if they are enabled or disabled. Additionally, a
listing of the stability sensors indicating they’re mounted
as standard or inverted.
Figure 26