Bendix Commercial Vehicle Systems SMARTIRE TPMS OPERATORS MANUAL - Manual (Page 31)

31
Below is a list of menu items available in Setup Mode and their application:
Menu Item Application
Change Units Use this menu item to change the units of measure from imperial to metric
or from PSI to Bar to kPa.
Vehicle Params Use this menu item to adjust alert thresholds.
Axle Params Use this menu item to program the cold inflation pressures (CIP) per axle.
Altitude Adjust Use this menu item to add or remove altitude compensation (requires
ambient pressure sensor).
Screen Contrast Use this menu item to increase or decrease screen contrast.
Buzzer Use this menu item to customize the audible alert (requires audible alert
module).
Learn Sensors Use this menu item to program new sensors into the receiver or change the
wheel position assigned to a sensor.
Profile Definition Use this menu item to select the number of axles and wheels per axle for a
new vehicle profile definition. This menu item will also overwrite the
existing definition and relearn all sensors after a new profile definition has
been completed.
Change Password Use this menu item to change the password for accessing the setup mode.
To scroll to the next menu item on the list, press the left button. To select a menu item, press the
right button. Below is a description of each menu item.
5.6.1 Changing the Units of Measure
The default "units of measure" setting is usually customized for the region in which the SmarTire
™
system was sold. Use the steps below to customize the units of measure.
1. Enter the Setup Mode using the steps outlined in section 5.6.
2. When in the Setup Mode, press the left button until “Change Units” is highlighted. Then
press the right button to select the function.
3. Temperature and Pressure options will then be displayed along with the corresponding
unit of measure. Press the left button to scroll between Temperature and Pressure and
press the right button to select the highlighted option for customization.
4. Press the left button to scroll between the different units of measure options. For
pressure, the options are PSI, Bar, and kPa. For temperature, the options are degrees
Fahrenheit and degrees Celsius.
5. Select the desired option by pressing the right button and the display will revert to the
Temperature and Pressure option screen.
6. Repeat steps 3 – 5 should further customization be required.
7. To save the changes and exit the “Change Unit” function, press the center button once.
Press the center button again to exit Setup Mode.