Bendix Commercial Vehicle Systems SMARTIRE TPMS OPERATORS MANUAL - Manual (Page 22)

22
Gateway Sensor Learn
a. To have the Gateway Receiver detect a sensor’s ID, click the ‘Learn Selected
Sensor’ button in the SmarTire
™
Diagnostics Software.
b. You now need to trigger a Learn transmission from the tire within the next two
minutes (or press ESC to cancel). This can be done using the LF Initiator Tool,
LF Tool, or Maintenance Hand Tool.
Press the Learn button with the device in the appropriate position shown below.
Check the manual for the tool you are using to select the Learn function.
c. Once triggered, it can take up to 30 seconds for the Gateway to receive the
transmission and complete the learn process. When successful, the sensor icon
in the tire map will turn green and the detected ID will be displayed.
4. Perform the above steps for each sensor on the tire map.
5. Sensor programming is now complete and the sensors are stored on the Gateway
receiver.