Bendix Commercial Vehicle Systems EC-60 ESP CONTROLLERS ADV - Manual (Page 23)

23
1st Number System Power
1 12 Volts
2nd
Number
Wheel Speed Sensors
4 4 Sensors
6 6 Sensors
3rd Number Pressure Modulator Valves
4 4 Modulators
5 5 Modulators
6 6 Modulators
4th Number ABS Configuration
1 4S/4M or 6S/6M
2 6S/4M
3 6S/5M
5th Number Traction Control Configuration
2 No ATC
3 ATC Engine Control Only
4 ATC Brake Control Only
5 Full ATC (Engine Control & Brake Control)
6th Number Retarder Configuration
1 No Retarder
2 J1939 Retarder
3 Retarder Relay
4 J1939 Retarder, Retarder Relay
7th Number Stability Configuration
1 No Stability Program
2 Electronic Stability Program (ESP), which
includes RSP
3 Roll Stability Program (RSP) Only
CHART 3 - SYSTEM COnfigURATiOn CHECk
Reconfigure ECU Mode
Controller reconfiguration is carried out by using the
Reconfigure ECU Mode. (See page 16.)
Note: To enter the Reconfiguration Mode, the blink code
switch must be held in before the application of ignition
power. Once the power is supplied, the switch is released
and then pressed seven times.
Troubleshooting and diagnostic trouble code clearing (as
well as reconfiguration) may also be carried out using
hand-held or PC-based diagnostic tools such as the
Bendix ® Remote Diagnostic Unit (RDU ™ ), Bendix ® ACom ®
Diagnostics software, or the ProLink tool.