Bang & Olufsen BeoLink Wireless 1 - User Guide - Manual (Page 13)

Connections – Power Link
In the main room: Connect the
transmitter to the Master Link
socket on the main system. Then
connect both the main system and
transmitter to the mains supply.
In the link room: Connect the
loudspeakers to the Power Link
sockets on the receiver. Connect
the ‘IR-eye’ to the socket marked
IR (for information about the ‘IR-
eye’ and its cable, see p. 14). Then
connect both the loudspeakers and
the receiver to the mains supply.
Check the indicator light in the
receiver to ensure that connection is
still intact. If the connection is lost,
the units must be moved. The
receiver switches to standby after
approximately 20 seconds.
Power Link cables: The cables must
be of the type which are marked
with a triangle on the plug. Do not
use any of the old type of Power
Link cables, as this will cause noise,
and thus not give optimum sound
quality!
IR
R T
PL ML PL
MASTER LINK
BeoLink
Wireless 1
BeoLink
Wireless 1
T R
Power Link
Mk 3
13
Main room Link room
Master Link
connection
Receiver/Transmitter
switch
Connection button
Light indicator