Bang & Olufsen BeoLab 3500 - User Guide - Manual (Page 22)

Ready for use …
When you have finished setting-up
BeoLab 3500, connect it to the
mains supply. Then switch on the
power for the main system.
When first switched on, the red
stand-by indicator in the display
will light up and, after a while, the
clock will be shown in the display.
However, if your main system is of
a type without the clock option,
the display will only show
:
Option settings
BeoLab 3500 can be set to the
following Options:
Option 0: Used if you want to
disable remote control operation.
Option 4: Used if you install
BeoLab 3500 in the same room
as your main system (for example
in a large L-shaped room with
two separate listening positions).
Option 5: Used if you set up a
Bang & Olufsen television in the
same room as BeoLab 3500.
Option 6: Used in a setup with the
main system in one room, and
BeoLab 3500 in another – as
described in this guide (this is
the factory setting).
Use a Beo4 remote control to set
the Option. The entire system must
be switched to stand-by.
> While holding down the • button,
press LIST.
> Let go of both buttons.
> Press
LIST repeatedly until
OPTION? is shown in the Beo4
display, and press GO.
> Press LIST repeatedly until L.OPT
is shown in the Beo4 display,
and then key in the appropriate
number (
0, 4, 5 or 6).
TIMER BANG & OLUFSEN MUTE
Option 4
Option 5
Option 6
22
For further information about the
display, refer to ‘Information in the
display’ (pp. 14–15) in this Guide.