Bang & Olufsen BeoLab 3500 - User Guide - Manual (Page 18)

>> Set up BeoLab 3500
To fasten BeoLab 3500 on a
solid wall:
– Mark and drill the holes in the
wall, using the bracket as a
template.
– Fasten the bracket to the wall. Use
the correct size and type of screws
and wall anchors, taking into
account the construction and
condition of the wall. Use three
screws and wall anchors each with
a minimum load rating of 13 kg
(29 lbs). Level the bracket before
tightening the screws (A).
– Detach the grey plastic cover (B)
from the wall mount and connect
the cables.
– Hang BeoLab 3500 on the bracket
by inserting the two plastic pegs
into the holes on the upper edge
of the wall bracket.
– Secure BeoLab 3500 to the bracket
with the two screws (C), and
attach the grey plastic cover again
(B).
56 cm
22"
56 cm
22"
A
B
C C
18