Autocue PC 90 - Manual (Page 9)

PC 90 MANUAL
VERSION 1.0 9  AUTOCUE 2001
In this mode the PC90 works on the principle of one Master and one or more slave stands in each group. The master stand in each group must be
numbered either 1 or 2, using the Stand number selector switch that is located on the ‘Shoulder of each stand.
The Slave Stand or Stands of number 1 must be numbered 9. The slave Stand or Stands of number 2 must be numbered 0.
When the stand number 1 is selected and a new height is entered all stands in-group 1 will move to the new height.
When the stand number 2 is selected and a new height is entered all stands in-group 2 will move to the new height.
Stand Configurations (Grouped Stands)
Set to No 1. Set to No 9. Set to No 2. Set to No 0.
Group 1
Group 2