Autocue PC 90 - Manual (Page 8)

PC 90 MANUAL
VERSION 1.0 8  AUTOCUE 2001
When all the stands are correctly connected and powered and switched on, the Remote Control Box will take a few seconds to
automatically detect any stands that are connected to the system.
Operation
Press Select Stand and input the required stand number (1,2,3) using the number keys, the new stand number is now displayed in the
Stand Number window. The “Current Height” of the selected stand will be displayed in the Current Height window on the Remote Control
Box. At the stands, set the required height of each individual speaker by using the Local Control, making a note of the Current Height displayed
on the Remote Control Box. To move the stands to the pre-determined heights, press Select Stand and enter the number (1,2,3), then press Set
height and enter the required height number 01 to 84. The new height will be displayed in the New Height window. Now press Move, the stand
or group of stands will now move to the new height entered. Pressing the Stop button will stop the command and the Cancel button enables you to
change the Stand Number and Stand Height.
Remote Control Operation
Stand
Number
Current
Height
New
Height
Number
Buttons
Select
Stand
Set
Height
Move
Stop
Cancel
The remote control panel will
control PC 90 stands individually
or in groups. It will display the
current height of the stands, the
stand number selected, and the new
height you wish the stand to move
to.