Ambient Controller - ACC 501 - Manual (Page 6)

ACC501
www.ambient.de
4
2.6 USB 2
Serves as MIDI TC I/O interface for sending MTC (Midi time code) to a DAW.
EXT power in, 5 Volts.
The Mini B USB ports follow the USB specification. It is recommended to have the Controller
powered on with the appropriate operation mode selected when establishing the
connection to a computer.
Do not connect to two computers simultaneously!
2.7 3.5mm Mini jack, TC in/out
Offers a separate LTC input/output carrying the same TC signal as the Lemo TC socket with a
reduced level of 1 Volt peak to peak.
Tip = LTC-OUT
Ring = LTC-IN
Sleeve = Ground
2.8 Sub D 15 pin socket, accessory I/O interface
This socket is for general access to the Controller and contains all connections needed to
interface to an external device including power. This socket can be used to connect the
ACCSI (Ambient Serial Interface) with attached GPS module. Various options like radio link
transceivers etc. to follow.
Only connect approved accessories to avoid damage.