Rockwell Automation Flex/WebPak 3000 DC Drive AC Line Discon Kit 1.5-30 HP-230VAC, 3-60 HP-460VAC - Manual

©2001 Rockwell International Corporation
FlexPak, WebPak, and Reliance are trademarks of Rockwell Automation
AC Line Disconnect Kit
for FlexPak 3000 and WebPak 3000 Digital DC Drives
1.5 HP to 30 HP @ 230 VAC
3 HP to 60 HP @ 460 VAC
Model Numbers 901FK0101 and 901FK0201
Instruction Manual D2-3292-3
Product Description
This instruction manual describes optional AC input line disconnect and lockout kits that can be installed on
FlexPak

3000 and WebPak

3000 Digital DC 1.5 to 60 HP Drives. Each kit includes a line disconnect
switch, mounting hardware, and wire assemblies for both chassis mounting and mounting in a NEMA 1
enclosure.
The kits provide a positive disconnect of all AC input leads for the FlexPak 3000 and WebPak 3000 drives. The
1.5-25 / 3-50 HP @ 230 / 460 VAC disconnect is rated for 100 amps at 600 VAC. The 30 / 60 HP @ 230 / 460
VAC disconnect is rated for 150 amps at 600 VAC. To comply with NEC codes, do not use either disconnect
for more than 85% of its rated amps.
!
ATTENTION: Only qualified personnel familiar with the construction and operation of this
equipment and the hazards involved should install, adjust, operate, and/or service this
equipment. Read and understand this manual in its entirety before proceeding. Failure to observe
this precaution could result in severe bodily injury or loss of life.
ATTENTION: The user is responsible for conforming with all applicable local, national, and
international codes. Failure to observe this precaution could result in damage to, or destruction
of, the equipment.
Table 1 – Verifying that the AC Line Disconnect Matches the Drive
Drive Horsepower/Voltage Rating AC Line Disconnect Model Number
1.5 HP to 25 HP @ 230 VAC 901FK0101
3 HP to 50 HP @ 460 VAC 901FK0101
30 HP @ 230 VAC 901FK0201
60 HP @ 460 VAC 901FK0201
Trademarks not belonging to Rockwell Automation are property of their
respective companies.