Rockwell Automation LZ-COOLKIT Linear Motor Cooling Kit - Manual

Installation Instructions
LZ Linear Motor Cooling Kit
Catalog Number LZ-COOLKIT
Inspect Kit Content Before attempting installation, verify the contents of your kit.
Install the Cooling Kit To install the cooling kit, do the following.
1. Use an 8 mm wrench or nut driver to install the M5 plug fitting in the side
tapped hole.
Torque to 3.4 Nm (30 lbin).
2. Place the o-rings into the two counterbores.
Item Description Quantity Illustration
1 LZ linear motor cooling manifold 1
2 M5 plug fitting 1
3 O-ring 2
4 M4 x 16 mm A2/SS socket head cap screw (SHCS) 2
5
Barb fitting
(1)
Hole inner diameter (ID) 2.4 mm (0.09 in.),
outer diameter 3.9 mm (0.15 in.)
(1) Suggested tube ID 3.2 mm (0.125 in.).
2