Rockwell Automation 20D PowerFlex 700S and H Fan Inverter Upgrade Kit (Frame 9) - Manual

Installation Instructions
PowerFlex 700S and 700H Fan Inverter Upgrade Kit (Frame 9)
Introduction Use this document to upgrade the fan inverter on a PowerFlex 700S or 700H
frame 9 drive.
What this Kit Contains Verify that your kit contains the items listed in the following table. If your kit
does not contain the correct items, contact your Allen-Bradley sales
representative.
ATTENTION: To avoid an electric shock hazard, ensure that all power to the drive
has been removed before performing the following.
ATTENTION: To avoid an electric shock hazard, verify that the voltage on the bus
capacitors has discharged before performing any work on the drive. Measure the
DC bus voltage at the DC+ & DC- terminals. The voltage must be zero.
ATTENTION: HOT surfaces can cause severe burns. Do not touch the heatsink
surface during operation of the drive. After disconnecting power allow time for
cooling.
ATTENTION: Hazard of permanent eye damage exists when using optical
transmission equipment. This product emits intense light and invisible radiation.
Do not look into fiber-optic ports or fiber-optic cable connectors.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts
and assemblies. Static control precautions are required when installing, testing,
servicing or repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with static control
procedures, reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection handbook.
Part No. Quantity: Description
FR09968 1 Connector Plate, EMI Protection Plate, Fan Assembly
and Fan Motor Capacitor
133256 1 Disposable Static Discharge Wrist-strap