Rockwell Automation THR Hot Repair Adaptor - Manual (Page 5)

THR October 2005 – Issue 6 5
Triguard SC300E THR Hot Repair Adaptor
6. Attempt to fully engage the adaptor card but if excessive resistance is felt remove the
card and check for bent pins or any other obstructions.
7. Using items 2, 3 and 4 fit one of the shrouds to the card over the pins of the left hand
connector; ensure that the shroud is correctly oriented (keys on the left, Figure 3-1. ).
Note that the two spacers (item 2) fit between the shroud and the card. Do not over
tighten the screws.
8. Using items 4 and 5 fit the shell (item 7) to the card over the short pins of the right
hand connector. Do not over tighten the screws.
9. Insert the cover (item 6) into the shell (item 7).
10. Repeat steps e) to i) to fit the other adaptor card to the remaining two field connectors.