Rockwell Automation MinPak Plus DC Drive Double Pole CB Kit for NRG 14C210, 14C211, 14C212, 14C213 User Manual

Product description

Reliance and MinPak are trademarks of Rockwell Automation.

Double Pole Circuit Breaker Kit

for Non-Regenerative MinPak Plus DC Drives

Model Numbers 14C210, 14C211, 14C212, and 14C213

Instruction Manual D2-3385

Product Description

The standard power on/off circuit breaker on single-phase, non-regenerative MinPak™ Plus DC drives is a
single pole, magnetic trip/manual trip unit that provides overcurrent protection for the drive’s power devices.
The Double Pole Circuit Breaker provides an additional degree of protection by removing all power from the
control circuits. When tripped, the Double Pole Circuit Breaker opens both

input conductors (L1 and L2)

between the drive’s power devices and drive terminal block 1TB.

The Double Pole Circuit Breaker must match the drive’s horsepower and voltage rating, as shown in table 1.
Refer to your drive’s nameplate for the horsepower rating.

The Double Pole Circuit Breaker kit includes the circuit breaker, connecting wires, and the required mounting
screws. No other options are needed when using this kit, and no user-supplied parts are required. The
contents of the kit are listed in table 2.

ATTENTION: Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, operate, and/or service this
equipment. Read and understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in severe bodily injury or loss
of life.

Table 1 – Verifying that the Circuit Breaker Matches the Drive

Drive

Model Number

Drive Horsepower and

Voltage Rating

Double Pole Circuit Breaker

Kit Model Number

14C10, 14C20

1/4 to 3/4 HP @ 115 VAC

14C210

14C11, 14C21

1/2 to 1-1/2 HP @ 230 VAC

14C211

14C12, 14C22

2 and 3 HP @ 230 VAC

14C212

14C13, 14C23

5 HP @ 230 VAC

14C213

Table 2 – Contents of the Double Pole Circuit Breaker Kit

Description

Quantity

Part Number

Double Pole Circuit Breaker

65241 -76A , -77A, -56C

1. Supplied with model numbers 14C210/14C211, 14C212, and 14C213, respectively

Jumper Wire 182

608813 -80Y, -80R, -80S

Jumper Wire 52

608813 -80V, -80W, -80X

Harness Wire 51/52

608813 -81R

Mounting Screw, 6-32 x 1/4

601742 -2C

Instruction Manual

D2-3385