Barco MIVD 1218 - Manual (Page 20)

User manual MIVD 1218 20
Lifetime.....................Indicates the total time the display has been
operating, including the time in power-saving
mode
* Not in DVI mode
Timing information
V.Freq.......................The currently measured vertical sync frequency
H.Freq ......................The currently measured horizontal sync
frequency
Interlaced* ................Indicates if the connected video signal is
interlaced or non-interlaced. A check mark (3)
means Interlaced, a cross (2) means non-
interlaced
Inp.Clk*.....................The current dot clock frequency with which the
input signal is sampled
Lines/Frame .............The actually measured number of total lines per
frame. For interlaced signals, a frame consists
of 2 fields.
Sync* ........................The kind of connected sync
* Not in DVI mode
3.6. Adjusting Geometry
The Geometry menu allows you to adjust the parameters with which
the input video signal is sampled. As a consequence, the image
geometry is influenced.
Required test pattern
To obtain good results with the Autocenter function, it is necessary to
have a good image on which to perform the adjustment.
For Autocenter, the pattern should contain:
-
white or gray (min. 50%) pixels at the edges of the image (left,
right, top and bottom).
To perform the adjustments:
1 Turn the control wheel to display the Geometry menu.
2 Click the control wheel to enter the menu.
***MAIN MENU****
Geometry