Barco MIVD 1218 - Manual (Page 10)

User manual MIVD 1218 10
To remove the strap:
1 Position the display with its rear side facing you.
2 If the foot cover is mounted on the foot, lift up the 2 clips of the
foot cover to release the cover from the foot.
3 Pull the lower side of the cover towards you and simultaneously
slide the cover downward.
4 Pull the red strap out of the fixation holes in the foot.
To change the panel orientation:
1 Stand at the front side of the panel and take the panel at both
sides.
2 Very important: Tilt the panel before changing
the orientation.
Should you change the panel orientation without
tilting it first, you might irreversibly damage the
tilt & swivel mechanism.
3 To change from portrait to landscape, turn the
panel counterclockwise while tilting it slightly.
To change from landscape to portrait, turn clockwise.
2.4. Connecting the signals
To get access to the connectors, open the cover of the connector
compartment by pulling down the 2 clips of the cover.
To connect DVI signals:
1 Connect one end of the DVI cable to the DVI input (5) of the
display.
2 Connect the other end of the DVI cable to the video output of your
DVI signal source.
3 Rout the cable so that it enters the connector compartment at the
place where the cover is bulged.
Strap